Have you ever considered glitter as a starting point?

Was that a trailer for the entire trilogy? Cause holy shit that is a lot to pack into 90 minutes

I have no clue about that. I only recently stumbled across the orca setting while waging my own battle against excessively aggressive supports.

In Orca slicer, if you use tree supports and hybrid, an option appears (advanced must be enabled) for something like “Essential supports only”. It is so much better than spending all that time adding or blocking supports.

It says on the package that it’s artisanal, so I think that means it’s special.

Something about all the “evil boss” movies of the 80s and 90s really stuck with that generation. It’s like they picked out the lowest of lows from the movie and said “you know what as long as I’m better than that I’m a good boss and people should be happy to work for me”.

Link to duplicate is either broken or to a wildly different question.

Because that is what he’s programmed, or paid to do.

Dental insurance kept denying him.

For some reason I can’t read your comment in any other voice than Cheech Marin.
And then Tommy Chong’s response would have to be, “Yah man, I think the word you are looking for is Blimp.”

The deregulation of the 80s and 90s really screwed this country over.

That’s fine when you live alone, but it is going to make relationships difficult. Oof, and you will murder any children you have before they reach 3 years old.

Print with larger holes, but then use multiple layers. Like Russian nesting dolls, but each “doll” would be rotated very slightly.
Also, try slots in opposite directions. Horizontal slots nested inside vertical slots would effectively create a mesh.
Flat panel inserts could be printed easily and then slid into a circular holder.