I recently acuired a secondhand NUC8I5BEH and installed proxmox on it. But it randomly is unreachable from my LAN. There are no errors in syslog. When I connect a monitor there is no signal. So the NUC seems crashed. The fan is spinning and the LAN lights are on. It’s not viewable on my unifi controller and it’s not pingable. Where can I start looking for the problem?

  • glizzyguzzler@lemmy.blahaj.zoneEnglish
    1·
    5 months ago

    First try an HDMI dummy plug, in case the thing doesn’t dig no screen (classic intel firmware)

    Then try Debian + Incus, less Proxmox shims to go wrong. Install Incus via the “zabby” repo mentioned on the incus install page. Search for “LXD” if Incus help/guides aren’t enough for you, they’re the same thing (for now). Providing an ISO in Proxmox is really clunky, and incus smooths that out so nicely. And again, less Proxmox shims to go wronk

    • Guadin@k.fe.derate.meOP
      2·
      5 months ago

      Going to try both. Someone else mentioned the dummy HDMI plug as well, so I got good hopes for that. Also going to look into Incuss. Never heard of it before.

      • glizzyguzzler@lemmy.blahaj.zoneEnglish
        2·
        5 months ago

        It accomplishes the same thing as Proxmox (VMs and LXC containers, which are “lite VMs” for if you wanted a Linux VM), I recently learnt about it too! It is new, but it was backed by Canonical up until the LXD/Incus split so it’s very solid. Split because Canonical tried to control LXD heavily, so they forked and renamed it Incus.

        I just used Incus and it’s very nice, use the profiles to create a profile for “GPU pass through” and “macvlan”, among others you’ll find you want. Then make instances as needed! It was easier for me to use than Proxmox.